9. Part of the TestInside WAN is shown below:
TestInside2 configuration exhibit:
TestInside2#show ip route
C 192.168.1.0/24 is directly connected to Fa0/1.1
C 192.168.2.0/24 is directly connected to Fa0/1.2
TestInside network administrator has created a new VLAN on TestInside1 and added host TISC and host TISD. This administrator has properly configured switch interfaces FastEthernet0/13 through FastEthernet0/14 to be members of the new VLAN. However, after the network administrator completed the configuration, host TISA could communicate with host TISB, but host TISA could not communicate with host TISC or host TISD. Which commands are required to resolve this problem?
A. TestInside2(config)# interface fastethernet 0/1.3
TestInside2(config-if)# encapsulation dot1q 3
TestInside2(config-if)# ip address 192.168.3.1 255.255.255.0
B. TestInside2 (config)# router rip
TestInside2 (config-router)# network 192.168.5.0
TestInside2 (config-router)# network 192.168.3.0
TestInside2 (config-router)# network 192.168.8.0
C. TestInside1# vlan database
TestInside1 (vlan)# vtp v2-mode
TestInside1 (vlan)# vtp password TestInside
TestInside1 (vlan)# vtp server
D. TestInside1 (config)# interface fastethernet 0/15
TestInside1 (config-if)# switchport mode trunk
TestInside1 (config-if)# switchport trunk encapsulation dot1q
Answer: A
10. Given the partial router configuration in the graphic, why does the TIS-PC1 and TIS-PC2 with the IP address 192.168.1.153/28 fail to access the Internet? (Choose two.)
A. The NAT inside interfaces are not configured properly.
B. The NAT outside interface is not configured properly.
C. The router is not properly configured to use the access control list for NAT.
D. The NAT pool is not properly configured to use routable outside addresses.
Answer: AC
Ccna ccnp ccie 등 인증시험의 덤프를 제공
우리회사의 홈페이지는 http://www.killtest.co.kr 입니다.
제 msn는 testkr@hotmail.com 입니다.
야호메일주소는 killtest@ymail.com 입니다.
